Results 1 to 5 of 5
  1. #1
    Senior Tech 100+ Posts



    Join Date
    Dec 2009
    Location
    San Luis Obispo
    Posts
    138
    Post Thanks / Like
    Rep Power
    0

    FS-1028 ADF not feeding

    It looks like the ADF switches are ok.
    Open top cover - message to close cover.
    Open adf off glass - message to close adf.
    original in adf - message to remove original (after open top cover and close.

    ADF roller is down and doesn't lift, and when I run copy it scan from the glass and doesn't feed the original.

    Any idea?

    I have the service manual but there is nothing there in regard to the ADF troubles. (ADF=Document processor).


  2. #2
    Service Manager 250+ Posts
    Join Date
    Oct 2010
    Posts
    460
    Post Thanks / Like
    Rep Power
    21

    Re: FS-1028 ADF not feeding

    I had a bad harness cause this kind of issue.


  3. #3
    Service Manager 250+ Posts Phil B.'s Avatar
    Join Date
    Jul 2016
    Location
    Raleigh NC
    Posts
    430
    Post Thanks / Like
    Rep Power
    8

    Re: FS-1028 ADF not feeding

    Quote Originally Posted by gideon View Post
    It looks like the ADF switches are ok.
    Open top cover - message to close cover.
    Open adf off glass - message to close adf.
    original in adf - message to remove original (after open top cover and close.

    ADF roller is down and doesn't lift, and when I run copy it scan from the glass and doesn't feed the original.

    Any idea?

    I have the service manual but there is nothing there in regard to the ADF troubles. (ADF=Document processor).
    if I remember correctly ... there should be a separate manual for the ADF.


  4. #4
    Trusted Tech 50+ Posts The_Murph's Avatar
    Join Date
    Mar 2016
    Location
    Erie, CO
    Posts
    53
    Post Thanks / Like
    Rep Power
    3

    Re: FS-1028 ADF not feeding

    I've seen where the "spring clutching mechanism" for the adf will either be out of position, or the plastic tab that it pushes against will break out, causing the spring to not load up and retract the feed assy. let me know if I can clarify, I'm in a bit of a crunch right now.

    If you phrase your inquiry properly, you will get the answers you seek...

    Good Luck ... You'll need it! HAHAHA!

    ~Big Dan~

  5. #5
    Service Manager 100+ Posts



    Join Date
    May 2009
    Location
    Concord, NH
    Posts
    215
    Post Thanks / Like
    Rep Power
    19

    Re: FS-1028 ADF not feeding

    You most likely have a bad wiring harness as previously posted. If the user is constantly opening and closing the ADF the harness connecting to the main unit has developed a bad wire connection. The problem seems to be the wire hold down in the adf restricts the harness movement too much and stresses the connection in the connector to the main unit. On setup we remove the wire hold down in the adf and snip the ty-rap on the harness to allow the wires to move freely. Since instituting this procedure we have reduces adf failures by at least 50%.


Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-=-=-=-=-=-


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here