Results 1 to 6 of 6
  1. #1
    Junior Member
    Join Date
    Nov 2014
    Location
    Atlanta, GA
    Posts
    2
    Rep Power
    0

    Question Copystar CS520i Error Code C2250

    during copying the user called and they have a error code C2250.

    I pulled the charge assembly and it appeared jammed I think the gear was off a little, I reassembled it and then the wire cleaner was able to travel without binding .

    I reassembled the copier and ran the hard reset.

    after a few minutes the error code C2250 Reappeared. any suggestions please?

    I don't like to guess, and I'm a bit rusty getting back in to the service business

    Thank you in advance.


  2. #2
    Field Supervisor 500+ Posts Phil B.'s Avatar
    Join Date
    Jul 2016
    Location
    Raleigh NC
    Posts
    918
    Rep Power
    15

    Re: Copystar CS520i Error Code C2250

    Quote Originally Posted by Raydicks View Post
    during copying the user called and they have a error code C2250.

    I pulled the charge assembly and it appeared jammed I think the gear was off a little, I reassembled it and then the wire cleaner was able to travel without binding .

    I reassembled the copier and ran the hard reset.

    after a few minutes the error code C2250 Reappeared. any suggestions please?

    I don't like to guess, and I'm a bit rusty getting back in to the service business

    Thank you in advance.
    inspect the drive for the charge unit... make sure that gearing is good.. if fine replace charge assy


  3. #3
    Junior Member
    Join Date
    Nov 2014
    Location
    Atlanta, GA
    Posts
    2
    Rep Power
    0

    Re: Copystar CS520i Error Code C2250

    Thank you for the advice!

    I assume that is the motor assembly with the smaller motor inside ( see attached photo) correct? do you know what the drive voltage is for the motor?
    and can the drive assembly be replaced without the entire Main charge unit MC-710 and I am pretty sure the part # for that whole assembly is 302GR93071 or 2GR93071? Thank you for your assistance I"ll let you know if it works.

    I had taken it apart yesterday and it appeared ok but it was locked up after disassembling it and reassembling it then it worked. I reinstalled it and reset the copier and then i got the same error code after it tried a few times.


    Thank everyone for reviewing and Phil B for the advice! I'll check today

    Attached Images Attached Images

  4. #4
    Field Supervisor 500+ Posts Phil B.'s Avatar
    Join Date
    Jul 2016
    Location
    Raleigh NC
    Posts
    918
    Rep Power
    15

    Re: Copystar CS520i Error Code C2250

    Quote Originally Posted by Raydicks View Post
    Thank you for the advice!

    I assume that is the motor assembly with the smaller motor inside ( see attached photo) correct? do you know what the drive voltage is for the motor?
    and can the drive assembly be replaced without the entire Main charge unit MC-710 and I am pretty sure the part # for that whole assembly is 302GR93071 or 2GR93071? Thank you for your assistance I"ll let you know if it works.

    I had taken it apart yesterday and it appeared ok but it was locked up after disassembling it and reassembling it then it worked. I reinstalled it and reset the copier and then i got the same error code after it tried a few times.


    Thank everyone for reviewing and Phil B for the advice! I'll check today
    hey Brother.. hope it werks out for ya!


  5. #5
    Senior Tech 250+ Posts
    Join Date
    Oct 2010
    Posts
    470
    Rep Power
    22

    Re: Copystar CS520i Error Code C2250

    We found that in the long run just replacing the whole unit was cheaper than making 3 or 4 trips to try to isolate it to the motor or the charger itself. It never failed that whichever part we replaced first, it would turn out to need the other instead. Replacing the whole unit always got the job done in one.


  6. #6
    Senior Tech 100+ Posts daveh12's Avatar
    Join Date
    Jul 2012
    Posts
    120
    Rep Power
    12

    Re: Copystar CS520i Error Code C2250

    You can clean the charge wires very easily manual then just leave the motor unplugged. It's only for the charger auto clean. Will work fine without


    Sent from my iPhone using Tapatalk


Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-=-=-=-=-=-


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here