kYO-6500I FUSER ERROR C6030

[pontiac]

Cleared code, replaced fuser, engine pwb and fuser pwb, upgraded firmware. What else should i reset or replace, thanks for replys

[Geo]

I.H. Unit...

Have fun..

[pontiac]

I.H. Unit...

Have fun..

Thanks GEO, Yes i replaced IH pwb.

[Tonerkiller]

I would check that connector that the fuser plugs into.

[sparkycivic]

did you do u906 OR u163 to reset code?

[pascalb.]

Hello

There has been a change for this code since Firm V3.06
(Corrective measures for the C6030 error (Broken fuser thermistor 1 wire).
The service call error condition below is eliminated that depends on the environment and printing condition.
-The TH2 as thermistor 2 detects 30oC or less while the TH1 as the thermistor 1 detects 70oC or more during warm-up (eliminated).)

Can be tested with a new Firm.
best regard