Thanks: 
Likes: Hello
my problem is solved by putting all the values of the SIM 246 a (0)
thanks to my support Triumph Adler.
Dislikes: 0
Hello
my problem is solved by putting all the values of the SIM 246 a (0)
thanks to my support Triumph Adler.
Do not lament,do not mock,do not hate,but understand.
What was the setting before? Do you adjust these beyond default "0" values when installing or was it shipped that way?Originally Posted by pascalb.
default setting
Sans titre 6.jpg
After
Sans titre 7.jpg
Do not lament,do not mock,do not hate,but understand.
Thank you for this post. Though I would like to add in on this.
U246 did end up being the solution to resolve the buckling jam occurring with J6511. However, in my case, it required more adjusting than just setting the values to 0.
I needed to play with the settings for both "Width Front HP" and "Width Tail HP". My adjustments ended up being +2 Front and +8 Tail. Make sure to test it thoroughly to avoid a repeat visit.
Playing around with one at our shop, if I make changes in U246, then test in U240 as it says in the manual, I don't see any difference in the guides.
I've tried exiting the sims before going into U240, but that didn't change either. Any input appreciated.
Are you guys still seeing this jam J6511 ?
having u246 set at 0, it still seems to jam at time j6511
DF-7120 (1000 sheet) finishers.
We had our rep here a few weeks ago since it's still an open case. It has never been resolved.
Seeing the same issue J6511 DF-7120
3552ci
What did your rep say ?
Still waiting for something to try.
Reply With Quote
Bookmarks