Thanks: 
Likes: 
Dislikes: After replacing Hard Drive and performing U906 on Kyocera KM-2560 I am getting message "Unknown toner installed" but we always use OEM.
Any help to get this machine to recognize genuine toner would be great?
After replacing Hard Drive and performing U906 on Kyocera KM-2560 I am getting message "Unknown toner installed" but we always use OEM.
Any help to get this machine to recognize genuine toner would be great?
I'm thinking that you reset the destination at some point. Check sim U265. For Kyocera it should be 02. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Will definitely try it tomorrow and will post results. Thank you very much.
Yes. U265 was set to "0". Following your instructions did fixed "Unknown Toner..." error. Thanks again. You're the BEST!
Congratulations on your success. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Reply With Quote
Bookmarks