Hi everybody
Can anyone indicate me where the registration switch is located on the Kyocera KM 1650 machine. I am getting misfeeds and JAM 11 on the machine.
Thanks
Hi everybody
Can anyone indicate me where the registration switch is located on the Kyocera KM 1650 machine. I am getting misfeeds and JAM 11 on the machine.
Thanks
The registration actuator is in the middle just below the silver roller. The actuator sits in white cover and is spring loaded (usually). If the spring on the rear side pops off or is lost, the actuator may be slow to return causing misfeeds. Also check your rollers are not worn and the pick up roller is with the black (updated)ribbed rubber instead of grey.
Depending on paper you can get 70-120k out of those rollers, usually.
Sent from portable device using fast cheapset!
Firmwares HERE.OK Google! ... will I need Berrocca this morning?
It looks a lot like this:
I'm sitting 2 feet away from one.
photo.jpg
=^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Firmwares HERE.OK Google! ... will I need Berrocca this morning?
It's a great place to store extra paper, that's it though. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Bookmarks