Thanks:
0
Dislikes:
0
-
Taskalfa 3050ci always shows A3 in preview window
Has anyone seen this issue , im getting A3 displayed in preview window, if i place a4 paper on scan glass as soon as i close the adf is shows as A3, auto feeder is fine
-
Senior Tech
250+ Posts
- Rep Power
- 26
Re: Taskalfa 3050ci always shows A3 in preview window
Clean paper size detection sensors under the glass. May as well clean entire optical section while at it..
-
Re: Taskalfa 3050ci always shows A3 in preview window
Check the switch on the back right corner of the machine that the DP actuates when it is closed; I have seen them knocked out of position causing this issue. It is on the machine but the DP actuates it when closed.
-
Re: Taskalfa 3050ci always shows A3 in preview window
You also may need to extend the length of the plunger activator.
-
Re: Taskalfa 3050ci always shows A3 in preview window
Replaced the pwb ISC and all is good, strange thing was if I disconnected the adf it would read the correct size off the glass, as soon as I plugged in the adf it would always read A3 of glass
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks