A capacitor blew up at power supply , I fixed power sypply and an erro 6030 appeared .
This error is about thermistor . Can it be something else connected to power supply.
A capacitor blew up at power supply , I fixed power sypply and an erro 6030 appeared .
This error is about thermistor . Can it be something else connected to power supply.
DAMN RTFM! you post quite a few questions .... but it seems you NEVER look in the manual. When the rest of post problems here, we have already been thru the manual and it doesn't have a clear fix or the fix doesn't solve the issue and all possibilities have been exhausted.
the thermistor is in the fuser.
but the fuser heater turn on?
but instead of calling it back, you can not give it any information
What's the use of a forum otherwise?
Defective connector
cable or poor
contact in the connector.
Reinsert the connector. Also check for continuity
within the connector cable. If none,
replace the cable.
Fuser heater and power source PWB
(YC102)
Fuser unit and engine PWB (YC7)
Deformed connector
pin.
See page 1-4-15.
Defective triac. See page 1-4-15.
Defective fuser
thermistor.
Replace the fuser unit (see page 1-5-21).
Defective engine
PWB.
Replace the engine PWB and check for
for me: 1° misure resistance heater fus and correct tension
Broken fuser heater wire
Abnormally high fuser
thermistor temperature
Broken fuser thermistor
wire
Abnormally low fuser
thermistor temperature
Deformed connector
pin.
If the I/F connector pins of the fuser unit and
the main unit are deformed owing to foreign
matters, such as paper dusts, replace the
connectors or the units including the connectors.
Defective triac. Remove the power cord and check that the
resistance between terminals T1 and T2 of
the triac TRA51 is of several Mega-Ohms
and not shorted (see figure 1-4-2). If failed,
replace the power source PWB (see page 1-
5-35).
Figure 1-4-2
2° pwb
Bookmarks