pannel dead

[kashif]

my kyocera 3500i pannel is dead but when i am lifting Adf scanning lamp is giving light that mean scanner is on just pannel is dead

[LaRueda]

Try replacing the Op panel. I had the same issue ended up the Op panel.

[kashif]

Try replacing the Op panel. I had the same issue ended up the Op panel.

ok, i will try to arrange, thanks buddy

[LaRueda]

Does the motors turn on when you power on the machine? You're welcome bud

[djs9164]

Try replacing the Op panel. I had the same issue ended up the Op panel.

Most like Kelly just the touch screen if it's on.

Sent from my XT1635-01 using Tapatalk

[kashif]

Does the motors turn on when you power on the machine? You're welcome bud

when machine turn on, scanner is rotating, heater lamp also glow just pannel is not giving any light, even i checked pannel another machine,it's working

[djs9164]

when machine turn on, scanner is rotating, heater lamp also glow just pannel is not giving any light, even i checked pannel another machine,it's working

Is it Dim? If not look for the board it plugs into.

Sent from my XT1635-01 using Tapatalk

[kashif]

Is it Dim? If not look for the board it plugs into.

Sent from my XT1635-01 using Tapatalk

no not dim,even no any light is turning on, i cleaned ram and reinstall,but still same

[quitech]

Please how did you solve this problem because i have similarly problem with taskalfa 4500i

It seem like this panel dead is the mostly problem of taskalf 3500i to 5500i both of the colour models it

[Phil B.]

Please how did you solve this problem because i have similarly problem with taskalfa 4500i

It seem like this panel dead is the mostly problem of taskalf 3500i to 5500i both of the colour models it

read the thread...


no resolve but it an old thread

maybe start a new thread since a diff machine is involved