Kyocera Taskalfa 3500i Print too light

[pgrom]

I have a problem with Kyocera Taskalfa, it prints to light. I replaced the developer, drum, the contacts are clean , the machine not covered with toner. The image on the drum is good but the printout is too light. The copier has printed 100k

IMG_3163.jpg

Please Help

[copiertec]

Have you gone though all of the setup procedures when changing the drum and developer?

[dalewb74]

sounds like time to take care of the optics.

[pgrom]

Have you gone though all of the setup procedures when changing the drum and developer?

yes

the image on the drum is good when you cut the paper

[Happy Copier]

I have a problem with Kyocera Taskalfa, it prints to light. I replaced the developer, drum, the contacts are clean , the machine not covered with toner. The image on the drum is good but the printout is too light. The copier has printed 100k

IMG_3163.jpg

Please Help

Well I am very interested in the solution to this one.

Sent from my SM-G930V using Tapatalk

[richs]

Looks like you have a transfer problem.

[JR2ALTA]

I dont know how you can tell the image on the drum is good..it's possible but the drum is basically black.

I'd say transfer roller or HV board.

[pgrom]

I dont know how you can tell the image on the drum is good..it's possible but the drum is basically black.

I'd say transfer roller or HV board.

it is a black copy

IMG_3184.jpg

This is a drum image while making a copy

IMG_3183.jpg

[copiertec]

Agreed, with above. Have you checked the connector on the transfer roller unit? I have seen where it is not seated properly and causes this issue. Where the prints light prior to drum and developer change?

[Happy Copier]

Agreed, with above. Have you checked the connector on the transfer roller unit? I have seen where it is not seated properly and causes this issue. Where the prints light prior to drum and developer change?

Were these done in service mode?

Sent from my SM-G930V using Tapatalk