Thanks:
0
Likes:
0
Dislikes:
0
-
Senior Tech
100+ Posts
- Rep Power
- 32
In my experience Z folds are usally caused by a clutch overdriving. Most of the time it happens at the reg. rollers, but it is not the reg. clutch causing the problem, it is the pre reg clutch not stopping when it should. Usally replacing the pre reg. clutch solves the problem.
-
Technician
- Rep Power
- 31
I've ordered 302FZ93281 the drive feed assembly because i think it's a clutch causing the problem. I'm hoping that by replacing the whole unit it will cure the fault, i'll find out during the week and will update.
-
Technician
- Rep Power
- 31
The problem was caused by the feed clutch! All fixed
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks