Taskalfa 300ci

[Realtech]

I have installed a new Taskalfa 300ci is working fine but I just want to know how to enable the orginal preview on the control panel. So when you place a orignal on the platen glass you should see a preview on the control panel. many thanks.

[n25an]

	Quote:			Originally Posted by Realtech
	I have installed a new Taskalfa 300ci is working fine but I just want to know how to enable the orginal preview on the control panel. So when you place a orignal on the platen glass you should see a preview on the control panel. many thanks.

I will go check out my copier right now... and see if I can figure it out... I'll check back in 15 minutes...

[n25an]

	Quote:			Originally Posted by n25an
	I will go check out my copier right now... and see if I can figure it out... I'll check back in 15 minutes...

based on info from
Service Bulletin #: 8899/ 2H7-0036**Service Information**

this issue is to be firmware supported in the august 2009 firmware release... if that doesn't work for you then its probably not supported yet...

I will keep searching...

[n25an]

	Quote:			Originally Posted by n25an
	based on info from Service Bulletin #: 8899/ 2H7-0036**Service Information** this issue is to be firmware supported in the august 2009 firmware release... if that doesn't work for you then its probably not supported yet... I will keep searching...

called the help desk

no copy preview

there is a fax preview, scan preview and document box preview but no copy preview...

[Realtech]

Thanks a lot!!!!!!!!!!!!!!!!!!!!!!!!!!