Thanks:
0
Likes:
0
Dislikes:
0
-
Trusted Tech
50+ Posts
- Rep Power
- 32
I was hoping the new firmware would cure this too, I have two doing the same thing " stop / start 10 prints per minute !
then eventually locks up
after reboot it calls for toner
-
Senior Tech
100+ Posts
- Rep Power
- 31
hi,
can you tell the toner coverage of this machine?
I know from expierence that if the machine goes over the 20% toner coverage, the machine goes after approx. 2 A3 R/V prints goes into "adding toner". this is a fact,you can't do a thing about this, the changed some settings to prevent overtoning like in the previous models.
another topic; if the environment temp is relatively high, this can happen sooner than normal.
check also all fans and see if the filters are clean!
have fun
-
Senior Tech
100+ Posts
- Rep Power
- 0
I've now seriosly got problems with toners not lasting, not even close to the yield at all.
on most of my color taskalfa's
Please let me know.
-
Senior Tech
100+ Posts
- Rep Power
- 0
Re: Taskalfa colour range general reliability tips and tricks ?
Toners not lasting... Still a problem. Coverage about 5
Any ideas
Firmware is on ver 12
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks