Thanks: 0
Likes: 0
Dislikes: 0
Does anyone have some ideas about what would cause false "replace toner" messages on a TASKalfa 300ci? All developing units and toner cartridges were just replaced for a different issue. The main board was also replaced recently and firmware is at latest levels. Any ideas?
But I'm trying, Ringo. I'm trying real hard... to be the Shepherd.
Check the dev drive/cleaning motors, this is a known problem with these motors and they have been modified a couple of times now, I'll have a look for the mod bullitin and post it.
Ok, check the pdf's one refers to the motors I was talking about, be aware the part numbers have changed again since this pdf and are UK spec.
I forgot about the other pdf which refers to the toner drive it could be that.
Good luck.
I trimmed up the toner coupler on the two cartridges that were having the problem and it worked. Thanks a lot.
But I'm trying, Ringo. I'm trying real hard... to be the Shepherd.
Reply With Quote
Bookmarks