Mita pointsource xi 8020 (wide format copier)

[shady1988]

Please who can tell me about simulation mode codes for this machine?

I have a service manual for it but it minus the simulation mode codes???!!!!
Thanks..

[10871087]

Please who can tell me about simulation mode codes for this machine?

I have a service manual for it but it minus the simulation mode codes???!!!!
Thanks..

I don't think Kyocera Mita sold that wide format copier model here in the US, do you know what model number it crosses to in North America?

[shady1988]

Thanks for you I know 10871087 to enter the mode but can you provide me a table contain a list of those simulations for this machine model>>
Thanks..

[kmking]

I am in Australia we sold alot of these machines.If you take off the rear cover you should see the simulation chart...hope that helps..

[shady1988]

Thanks for your hellp kmking I know that man but I need a detail for thats simulations specialy the simulation active the controller key.. and what about you 10871087 do you can inform me about this subject??!!>>>
Thanks

[10871087]

Thanks for your hellp kmking I know that man but I need a detail for thats simulations specialy the simulation active the controller key.. and what about you 10871087 do you can inform me about this subject??!!>>>
Thanks

Huh??? I have never worked on an Xi-8020, does it cross over to a model number that was sold in the US?

what is the problem with your machine?

[kmking]

Hey there buddy,If you take the rear cover off the back of the machine it will have the simulation codes in there ,plus the default values of what the machine is set at.Hope this helps.

[milan]

give your e-mail i will send it to you