Thanks: 0
Likes: 0
Dislikes: 0
>On intialization the scanner moves freely back and forth-OK.
>On initialization the Scanner LAMP does NOT turn on.
>I also checked scanner motor ops in service mode-OK.
>Checked scanner lamp ops U061-Dead.
>Chacked DP Read U073-Dead.
>Cleaned and reseated all connectors-Still Dead.
I am wondering if the SCANNER INVERTER or SCAN LAMP are a common problem with these.
only 189,000 clicks
I was thinking scanner lamp assy or inverter PCB, am wondering what others have run into
Thanks,
Mike
It's not impossible, but I've never seen a bad exposure lamp or inverter on the Falcon III series machine. I've got machines over 1.5M prints.
The things you can do for free include pinning out the ribbon cable, and re-loading the firmware. Cost-wise, I would start with the lamp & inverter. It could also be the ribbon cable to light source 1 or the engine PWB, but I'd save those for the next round of parts replacement.
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Thank you Blackcat... I am about to go over there and do just that. My lamp and inverter PCB have arrived. I will post results.
It was the lamp inverter PCB. What a PITA to get to.
Good diagnostics. Thanks for sharing. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
i have one time seen it be the lamp itself. sounds like a very uncommon problem though. luckily i had a parts machine to get it up and running the same day. customer called in with the code, sorry i dont remember what the code is now
Re: Kyocera KM 4050i Error Code c3300 - No Scan Lamp
Hi ! i run into this code [3300] today ,when i replaced lamp inverter no luck the code [3300] still appear so i replaced scanner board when i turn on the machine what i saw is exposure lamp light up a second and smoke coming the end point of exposure lamp .Of course the error code [3300] appear . Any idea to solve this faulty ! Tx
Re: Kyocera KM 4050i Error Code c3300 - No Scan Lamp
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
Posting Permissions
Reply With Quote
Bookmarks