Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 6 of 6
  1. #1
    grumpytech
    Guest

    cs 4035-excess lead margin

    hi
    Has anyone seen too much lead void? I can make the void larger but not small enough. 3/8"
    Through feeder and on glass...I tried on one at the shop and the adjustments won't change void, but if I change print lead margin, it changes d.f. margin. but it won't go - even though it says -3mm... any ideas?
    Thanks

  2. #2
    Field Supervisor 500+ Posts Jimbo1's Avatar
    Join Date
    Mar 2008
    Location
    Broken Arrow, OK
    Posts
    845
    Rep Power
    41
    Ok do you have it center - lined? All the other adjustments right?
    "Some days you get the bear, some days the bear gets you."

    Cdr. William Riker

  3. #3
    Master Of The Obvious 10,000+ Posts
    cs 4035-excess lead margin

    blackcat4866's Avatar
    Join Date
    Jul 2007
    Location
    Lapeer, Michigan
    Posts
    22,442
    Rep Power
    462
    Maybe the reg clutch is magnetized, prefeeding the paper, making the image late.
    Do U034, top and left, then U402 for voids. If you still cannot get down to 3mm lead edge void replace the registration clutch, and do the adjustments again. =^..^=
    If you'd like a serious answer to your request:
    1) demonstrate that you've read the manual
    2) demonstrate that you made some attempt to fix it.
    3) if you're going to ask about jams include the jam code.
    4) if you're going to ask about an error code include the error code.
    5) You are the person onsite. Only you can make observations.

    blackcat: Master Of The Obvious =^..^=

  4. #4
    grumpytech
    Guest
    OK....With a finisher installed, "trail edge" on copies, is actually lead edge, in the "print" margin adjustments...(the one where you adj in .1mm) It did not have the print option so..... Problems like this make that ICECOLD Friday beer taste better!!! Have a good weekend........

  5. #5
    Master Of The Obvious 10,000+ Posts
    cs 4035-excess lead margin

    blackcat4866's Avatar
    Join Date
    Jul 2007
    Location
    Lapeer, Michigan
    Posts
    22,442
    Rep Power
    462
    Does this mean it's resolved? I'm guessing you were trying to adjust the lead edge void, but in actuality were adjusting the trail edge void. =^..^=
    If you'd like a serious answer to your request:
    1) demonstrate that you've read the manual
    2) demonstrate that you made some attempt to fix it.
    3) if you're going to ask about jams include the jam code.
    4) if you're going to ask about an error code include the error code.
    5) You are the person onsite. Only you can make observations.

    blackcat: Master Of The Obvious =^..^=

  6. #6
    grumpytech
    Guest
    UMMMMM, When I adj "trail edge margin" by the book, it changes lead void and when I go minus, I can eliminate lead void all together. By the book, that shouldn't be possible...just another day at the office...

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here