Kyocera FS-C8025

[brodera]

Hi!

I just got my first Kyocera FS-C8025.

I get this message in the upper left corner saying: Adjusting Scanner. And my scanner light is lightning up all the time.
bild.JPG

//Best Regards

[blackcat4866]

I came across something like this on a Falcon III once. It turned out that the top door on the DP was partly open, because someone had pried open the top door without using the release latch. The black plastic receiver through the rear frame was snapped off, and the latch was broken. If you inserted originals and pressed start the screen would display "Adjusting Scanner", the exposure lamp would light and stay lit, then stay like that unchanging until the machine was powered Off/On. If you held the door shut, the scanner adjustment completed and fed originals just fine.

I don't know if this is applicable to what you're seeing, but to me it sounds quite similar. =^..^=

[brodera]

thx for reply!

I just came back to work and was going to check the solution you said.
went to the machine and the light is not lit.. Humm strange...

Thanks anyway Blackcat!!!

[correo.tony]

Check the best connection of the cable and connector DP in rear machine,

Bye !

[chris@kokstadcopiers]

Check the best connection of the cable and connector DP in rear machine,

Bye !

Just got a TA 3010i in. Displays Adjusting scanner when copying, is copying but copies are very faint.
When printing a status page it is fine.

Any help will be appreciated.