I'm new to the Kyocera brand and have just replaced a Savin with one of these. The only complaint which is a small one is operation of Scanning. The Savin they had would hold the Scan destination and the settings so when they went to to Scan their next document all they had to do was input file name and hit start. The Kyocera automatically boots the destination after each the packet is scanned. So they have to re input the destination every time. Normally this wouldn't be a huge issue but this customer spends a lot of time scanning different files at one time. I haven't found any settings to change this and from the people I've talked to there isn't anything to change this. We are looking at installing Drivve possibly but I wanted to see if anybody else has ran into this and has found a solution. I've played around with Panel Plus and FMU connect and those both seem to set up a profile with a preset file name. But also I'm not familiar with these programs so I'm still playing around to see of I'm doing something wrong. Thanks for any Ideas.