Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2
  1. #1
    Strat
    Guest

    Mita DC 1205 damp dev

    I replaced Dev.and the drum. the copier worked good for short while then it start damping the dev on one end of the dev unit and that end is inside of the machine, the toner or devoloper will be droped in trans cw and trans cw unit and it will not fused.

    I checked Dev unit structure it self no fault found.

    What is the idea for this?

    Thanks for any help.


  2. #2
    Trusted Tech 50+ Posts dqydj's Avatar
    Join Date
    Jun 2005
    Location
    spokane wa
    Posts
    64
    Rep Power
    26

    Re:Mita DC 1205 damp dev

    your developing unit is warped. If you take the unit out of the machine
    and set it on a flat surface you will see that it is bowed up in the center
    under the mag roller.
    This causes the developer to flow usaully to the back but I\'ve also seen
    it flow foreward and dump off the end of the mag roller.
    You can get the housing for the DV unit from Mita but I\'ve
    found it easier to just replace the whole unit


Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-=-=-=-=-=-


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here