hello guys
we try to use olivetti toner for fs-6025 after few copies "toner container not installed" massage appears and massage still appears also after installing genuien toner. machine firmware is up to date. we try to change u265 to 0,2,12,14 and same error.
So if it started out as a Kyocera Mita, sim U265 was at 02, then you changed the destination to Olivetti: 12? If the cartridge physically fits, that's all that needs to be changed. Which badge does it display in the web interface? =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
I would "hope" this problem is fixed on this model, but the problem existed on the Taskalfa 255 & 305. Bad chip on the board. Only way to fix it is to replace the PWB.
I had a 2126 do this. Cleaning the black flat plate sensors on the left side under toners and reseating connections on the main PWB,, especially the flat ribbon cables, fixed mine.
I've replaced the engine pwb
Having the same issue on a Kyocera 255. I have replaced the Engine PWB and the machine comes to ready. It will make one copy and that copy stops in the fuser and gives a j0000. When I clear the jam the machine says "Check the toner container" again. Open and close the front door and machine tries to print again. It does this in an endless cycle.
Any thoughts would be appreciated.
Service Bulletin B293-2K3-0019
[Problem]The “Please install toner container.” message may display even if it is installed correctly.
Field Measure Please replace with new engine PWB if the problem occurs
Your message is machine says "Check the toner container" Did you order a NEW board or rob one from a parts machine? Maybe your parts machine had the same issue??? If you have a parts machine try replacing the MAIN PWB and run Service Mode U004 when you get a S/N mismatch error
Good luck
It was a new board from Hytec
I've got a lot of these in the field and have never seen the board problem, but I have seen a bad chip on an aftermarket toner. Make sure the toner works in another machine.
Posting Permissions
Thanks: 
Likes: 
Dislikes: 
Reply With Quote
Bookmarks