Good Day,
In regards with kyocera mita TASKalfa 400ci,i need to know the procedure of enabling the finisher,or it is enable automatically when connected to machine...
thank you :-)
Good Day,
In regards with kyocera mita TASKalfa 400ci,i need to know the procedure of enabling the finisher,or it is enable automatically when connected to machine...
thank you :-)
If you connect it and it is not recognized you need to go into the service mode and execute a simulation 906, reset disable function.
All Kyocera options are plug & play. If the option is not recognized the most common problems are connectors or the accessory is isolated due to an error. U906 should clear an error. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
thanks guys,i will give you feedback if it's resolve..
its done,working fine...thanks a lot.
Bookmarks