light area across copy

[Orion]

Got a kyocera 2050 with a light area across copies when using ADF and a dark area in the same area when using the exposure glass. Yet printing to the copier is fine. Replaced so far exposure lamp and CCD. Any ideas out there?

[yakyitz]

You might want to refer to the following thread

http://www.copytechnet.com/forums/sh...rints-are-fine

[MR Bill]

This is a very simple fix. CLEAN YOUR OPTICS AND UPPER FUSER ROLLER. I know you already cleaned the mirrors right? Clean them again. Hard to see the film on them but they are coated a little bit . Most of the time in the middle. Burning plastic fumes from the fuser area comes up into the optics area. Turn down your fuser temp about 10 deagrees also.

[JustManuals]

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


http://www.justmanuals.com


Paul@justmanuals.com