Copystar CS 6030 "Time for maintenance" Message How to clear

[monstott2010]

2,584,120... I am really impressed with that machine... very few jams. They say it's not 2 siding very well though. I'm going to look into that tomorrow...

properly serviced you will get a lot more of it.... we had one hit nearly 12mil in 5 years.....

[habik]

properly serviced you will get a lot more of it.... we had one hit nearly 12mil in 5 years.....

if I tell my boss he will never buy any other for the next 5 years lol...

I agree with good maintenance and mainly good training...5 mil. is always good. how many main drives have you changed so far?

[Doug James]

if I tell my boss he will never buy any other for the next 5 years lol...

I agree with good maintenance and mainly good training...5 mil. is always good. how many main drives have you changed so far?

Main drive motors ? None yet... Had this machine for about 4 months so far... Are motors a problem for this ?... After sitting around for a few years before taken out of storage, I did have an issue with the developer motor. It hasn't become a problem since I put a new housing in it...

[habik]

arround 1.8 - 2.5 mil I have changed the main drives the motor and the gear running fuser will eventually wear out.. there is thread about this on the forum. I usually order the whole drive unit assembled in factory as there was a batch of spare motor shafts that had slight dimension intolerances and when put in the old drive unit it had a heavy drive and wear out quick or even worse produced issue, jam, noisy, C-code.
They good machines please don't get me wrong, as long as you have mods in they are sweet as a nut. Have you got the copper like looking springs on feed units ?

few good threads

Duplex:http://www.copytechnet.com/forums/sh...ght=km6030+mod

Jam 50 or 46
http://www.copytechnet.com/forums/sh...t=km8030+habik

[Doug James]

arround 1.8 - 2.5 mil I have changed the main drives the motor and the gear running fuser will eventually wear out.. there is thread about this on the forum. I usually order the whole drive unit assembled in factory as there was a batch of spare motor shafts that had slight dimension intolerances and when put in the old drive unit it had a heavy drive and wear out quick or even worse produced issue, jam, noisy, C-code.
They good machines please don't get me wrong, as long as you have mods in they are sweet as a nut. Have you got the copper like looking springs on feed units ?

few good threads

Duplex:http://www.copytechnet.com/forums/sh...ght=km6030+mod

Jam 50 or 46
http://www.copytechnet.com/forums/sh...t=km8030+habik

This Info is SO HELPFULL !! THANKS SO MUCH !!!. (The springs were actually included in one of the kits and I installed them)

[sham.panhale]

I have KM8030 with counter 5662671 and still working fine.

properly serviced you will get a lot more of it.... we had one hit nearly 12mil in 5 years.....

[jarhead]

I looked in the service manual and cleared U904 and some of the other counters. The message is still their. Thanks so much for any help !!!

go into U251 start reset start that clears your maint count and starts you count over to the regular cycle also empty your waist toner and reset that count u921 start reset start same with fuser. hope this helps