I have a KM-5035 that has intermittent CQ problems. Sometimes I get a 4 to 5 inch void in the middle of the page when doing a lage copy job over 500 when running under a 100 copies at a time it works perfect. The DV Unit , high voltage board, power supply and drum has been replaced no change and power has been tested also.
Any Ideas
Last edited by jeromeblanks; 04-04-2014 at 12:12 AM.
How about a sample? =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Samples would really help as Blackcat stated. Also, only things to cause voids are the laser unit glass being dirty or the transfer section. Check your transfer roller.
Did you replace main charge w/drum unit? Youtr post didn't specify.
Posting Permissions
Thanks: 
Likes: 
Dislikes: 
Reply With Quote
Bookmarks