For those of you who were wondering, we brought in a regional tech, and he determined it was the lasers that went bad and had us order 4 new lasers for the machine. Ill let you know when we get them if it resolves the issue.
For those of you who were wondering, we brought in a regional tech, and he determined it was the lasers that went bad and had us order 4 new lasers for the machine. Ill let you know when we get them if it resolves the issue.
Not to digress, this same regional rep also told us "Half the time when I take apart a 2126, they end up never working again." in reference to our graveyard of them.
Needless to say, Kyocera Color units are a hardly a stroll through the park.
Just browsing through this thread and really have not give thorough thought to the whole problem. The above in red caught my attention. I have repaired lots of fs-2126 and not one went to the graveyard. yes, they require a bit of work to do the mod, but when done they work fine and usually after assy, works gracefully. replacing four lasers to correct this problem, very, very unlikely, if fact i would say a plain na.
print in monochome only and see if that laser is good, and if good you can swap around the lasers [if they are the same, which i think they are] and start there.
Also, u89 colour belt. what do they look like.
THE ONLY THING FOR EVIL TO TRIUMPH IS FOR GOOD MEN TO DO NOTHING..........edmund burke
2n4-0032.pdf This should help.
Bookmarks