I have a Kyocera FS-4300DN printer with a 0501 jamming issue. It is not everytime, but still frequent. Also, it is never the first print, it's always after it has printed several. When it jams, it is consistently the same jam, in the same spot give or take an inch or so. It usually jams every 20 or so, but sometimes will feed up to a hundred or so. The paper from Tray 1 is pulled out of the cassette by the tray 1 feed rollers, and then gets onto the 2 big middle feed rollers and jams. You remove the image formation unit and sometimes you can see the paper from looking in the machine. Usually you cannot, and must retrieve from the cassette, then, of course, there is a paper jammed halfway through the exit unit. The paper is always out of the fuser rollers in the exit rollers. The jam code is “0501 No paper feed of jam - The registration sensor 2 (RS2) does not turn on during paper feed from cassette 1." This sensor is located on the bottom of the drum unit. It never jams while feeding from the bypass. Only jams from tray 1. That eliminates most of the paper path. (There are no other trays added to this machine)
What I have done to troubleshoot:
Current firmware has been reflashed twice.
Thoroughly cleaned the middle feed rollers
Replaced the tray 1 feed tires (as a unit)
Used 2 different new drum units to verify the RS2 works although it jams before getting there
Replaced the Paper Feed Drive pack with 2 different new units (has 2 clutches and 1 solenoid)
Replaced the entire tray 1 cassette with a new one
Most recently,
Replaced the tray 1 lift motor (that one was no fun)
Replaced the tray 1 lift sensor
After talking to the Kyocera techline, they had me leaning toward an issue with lifting the paper to the tires so that’s why the cassette, lift motor, and lift sensor were replaced. No difference from those, though. I called Kyocera again and they basically said good luck, we have no other suggestions.
My next step, I guess, would be a wiring harness for the paper feed clutches since one kind of looks like it was pinched at one time, but that may be reaching. However, I don’t see the wiring harness in the parts list.
Or possibly a main PWB.
Please let me know of any suggestions.
Bookmarks