Thanks: 0
Likes: 0
Dislikes: 0
Changed in the printer development unit magenta and the print quality was poor.
Magenta periods over the entire sheet. Calibration is performed.
pic here https://plus.google.com/u/0/photos/1...20402926187457https://plus.google.com/u/0/photos/1...20402926187457
If it wasn't doing this before you changed the magenta developer, then the new unit is probably defective.
wasOriginally Posted by darry1322
CAM00082.jpg
and now
CAM00085.jpg
period similar to the circle of the magenta shaft of the magnetic drum .
And this problem does not occur for the first time. The last time helped the new firmware and cleaning contacts. What exactly helped in that time did not know and had a problem with yellow.
I'll have to agree with darry. If the problem is introduced with the new magenta developer, then that's the most likely source of the problem. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
If the problem persists, and with another new development unit of the new kit?
And me, I immediately and the developing unit and drum.
Looks like a dev bias ground fault or ITB inner roller fault ???
Inauguration to the "AI cancel-culture" fraternity 1997...
•••••• •••[§]• |N | € | o | M | Δ | t | π | ¡ | x | •[§]••• ••••••
I was thinking similarly:
check charge contacts
check transfer belt to HVT contacts
Is it OEM toner?
=^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Make sure you run the AC Calibration once you replace these. I've had that solve this problem before. Otherwise it's a bad DV unit.
u464 ?
Yes. If you look at the insert, Kyocera recommends that you run U464 twice. Both before and after color registration. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Posting Permissions
Reply With Quote
Bookmarks