Hi had to load firmware on a FS 9530 the other day and it didn't go too well.
I had a look at the instructions and usb stick seemed the easiest way.
The firmware extracted to three folders
Engine
System
Panel
The engine folder looked like this
kyocera firmware.JPG
I copied download.bat and the bin file to the root of the stick and plugged it in, Supervisor mode appeared on the screen which looked good, after about twenty minutes a message appeared that looked like the level of firmware that was loaded so I assumed it was done.
I did the same for system and panel folder.
After that I get a message about a parallel interface or something like that.
Where did I go wrong?
Bookmarks