FS 2126nfp

[zoraldinho]

There is a bulletin that addresses the registration problem. Check the reg shutter is working. Replace the transfer belt. Use special firmware to reset the registration.

Hi dude,

I can't find this tool on the partner site.Do you know maybe the name or the title exactly for this tool?


Thanks,Z

[Tonerkiller]

Just keep adjusting. Made sure that you are adjusting in the right direction. You might have to do the max adj 10 times to get it right. Each max adj moves it very little. I have been there.

[Kidaver]

If you can get it lined up on color registration and then it is going out of alignment after a few auto calibrations then the problem is most likely with the shutter not opening and reading the color patch or a problem with your idc sensor. If the IDC sensor can not read the patch it just keeps adjust out of alignment getting worse each time.

[zoraldinho]

If you can get it lined up on color registration and then it is going out of alignment after a few auto calibrations then the problem is most likely with the shutter not opening and reading the color patch or a problem with your idc sensor. If the IDC sensor can not read the patch it just keeps adjust out of alignment getting worse each time.

you nailed it Kidaver! I think the same but i come back with proof.


Thanks Tonerkiller

Z

[tmaged]

Here's the bulletin. Following it has worked for us.

[kaborwen]

Please use the detailed pattern instead of the normal registration. Good luck.

[zoraldinho]

Just keep adjusting. Made sure that you are adjusting in the right direction. You might have to do the max adj 10 times to get it right. Each max adj moves it very little. I have been there.

Adjusting 8 times helps.So far so good.Thanks guys.


Z