Hi all,
I have a problem with a TASKalfa 520i. When copying from glace or DP, it's coming black but all prints are OK. I need solution or service bulletin please.
The firmware is update.
Thx.
Hi all,
I have a problem with a TASKalfa 520i. When copying from glace or DP, it's coming black but all prints are OK. I need solution or service bulletin please.
The firmware is update.
Thx.
What happens when you scan?
Does the lamp light?
Some possibilities:
Exposure lamp
CCD
Scan Control Unit
Harnesses
Main PWB
=^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Sounds like you lost your scanner settings, I've had this a few times on 300i's and 520's. You need the special test charts to perform Sim 411 & 425 to get them back.
You can see the scans samples. in color and B/W mode. Maybe can help for solution. Thx
B&W Scan.pdf
Color Scan.pdf
Yes I would suggest charts. Had similar happen on a M2535 would come out white no image. Performed service modes with special charts all was well.
Bookmarks