co64o{ Km8030 }

[Franky Tan]

At 1st i face with auto feeder faulty whenever i placed original copy on feeder tray,its show reset document processer, but i use u244 to check all sensor and switch its ok.I replaced DP main pcb board ,the feeder still show reset document processer whenever i placed original copy and i use u906 its come out with system error co64o, i replaced engine board and hdd but still cannot settle the problem.thank to all.

[kwazimoto]

ISSUE DETAILS Related Models: KM-8030
Issue Category: ERRATIC OPERATION
Closed Date: 2006-05-24

Print Page can not be combine showing reset. then code 0640. tried formatting no help. replaced HDD and formatted stopped with code 4579. then tried the main PCB and format came up with same code. bad HDD & bad paper feed deck pcb, replaced to resolve

Close If you need to receive additional support for this issue, Be sure to include any additional information or questions that you may have. Also, please be sure to be as descriptive as possible.<H5>Please Click Here



</H5>

[Franky Tan]

[quote=kwazimoto;28100]
ISSUE DETAILS Related Models: KM-8030
Issue Category: ERRATIC OPERATION
Closed Date: 2006-05-24

Print Page can not be combine showing reset. then code 0640. tried formatting no help. replaced HDD and formatted stopped with code 4579. then tried the main PCB and format came up with same code. bad HDD & bad paper feed deck pcb, replaced to resolve

Close If you need to receive additional support for this issue, Be sure to include any additional information or questions that you may have. Also, please be sure to be as descriptive as possible.<H5>Please Click Here

Hello ! kwazimoto, when i click H5 i didn't see anything come out
can u please send again. Thanks to
u .if u can reply again. Because i need solution on Monday.I thinking to replace DIMM on main board u think is it posible to solve. Anything link with mainboard?how about Hv unit? i remember that i experieced falcon2 machine before co64o appear after i replaced dimm on main board the problem solved.

[blackcat4866]

I believe kwasimoto has suggested replacing the HDD and paper feed deck PWB as a set (concurrently).

=^..^=

[Franky Tan]

	Quote:			Originally Posted by blackcat4866
	I believe kwasimoto has suggested replacing the HDD and paper feed deck PWB as a set (concurrently). =^..^=

I will try it tomorrow , keep u inform later. thanks.

[Franky Tan]

	Quote:			Originally Posted by leaw heng keong
	I will try it tomorrow , keep u inform later. thanks.

My supervisor went down to repair the machine ,been told that HDD got three connector ,the center connector needed jumper which is forgotten by me.