Kyocera Mita FS-4100DN. After replacing fuser everything seems to work but when you turn printer on it produces 2 loud clicks coming from the fuser area.
What did I do wrong? Please help.
Kyocera Mita FS-4100DN. After replacing fuser everything seems to work but when you turn printer on it produces 2 loud clicks coming from the fuser area.
What did I do wrong? Please help.
did you remove it and try to reinstall in case you missed something?
Did you rotate the fuser by hand to see if you can hear the noise?
Growth is found only in adversity.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Good tips. Thank you guys. Will try when I am visiting this site.
Also be sure to check the gears in the transmission section
Try to take out the fuser. Look on the right hand side. You should see a black plastic cam in the up position. Plug the printer in until it rotates downward. Then rip the plug out and reinstall.
Bookmarks