My FS-1118 MFP has the C6000. What do I have to do to solve that problem???
My FS-1118 MFP has the C6000. What do I have to do to solve that problem???
replace the fuser will fix that. Or if you want to stip it down check the lamps and if their ok change the thermistor and thermostat. But your better off just replacing the whole unit
You have to run U163 to clear the code, even if you replace the fuser.
Thanks for your help!!!
Here is what really helped.
Works with ERROR C6000, C6300, C6400
Switch off
Open Toner Cover
Switch on, holding "System Menu"
Go to "Secure Setting"
"Enter"
Hold "Start" "#" "Enter"
Scoll down to "Maintenance Mode"
"Enter"
Scoll down to "U163"
Scoll do "Execute"
"Enter"
Close Toner Cover
Leave run for a few seconds
Switch off
Switch on
hello
there is no secure setting on the panel there are other settings
I tried other settings , no result
what is the problem , what can I try other ?
hello
this is what help me , open front cover , press menu system, go to service settings
press start # then enter go to reset fix error u 163 press enter then execute
switch off than on
A day late and a buck short. the original post is 3 years old.
Bookmarks