FS-2000D

[Wile E. Coyote]

Got one of these stuck at selftest. Does a firmware upgrade solve this issue ? thanks, wile e.

[bsm2]

remove and reseat all units

any motor sounds ? does fuser heater come on?

[TheOwl]

There is a possibility that a firmware upgrade could fix your issue. It wouldn't hurt to have the machine at the latest version anyway.

[madas]

	Quote:			Originally Posted by Wile E. Coyote
	Got one of these stuck at selftest. Does a firmware upgrade solve this issue ? thanks, wile e.

try firmware if not may be main control board, have had on other models but not this one

[slanwar]

I have 3 FS 2000d's with the 150 error message, I know that's the firmware update but I have no idea where I can get the files, since Kyocera doesn't have on their site. I replaced any board I could see from a good printer but the error stayed there, which board I suppose to replace? Any site were I can download the manual?
Thanks in advance.

[slanwar]

I forgot to say on my previous post but I have also another fs 2000d which prints black pages, replaced transfer roller, developer unit and toner and still prints black pages.

[madas]

	Quote:			Originally Posted by slanwar
	I forgot to say on my previous post but I have also another fs 2000d which prints black pages, replaced transfer roller, developer unit and toner and still prints black pages.

stick a bit of electrical tape over part of the laser opening and do a print, if you get a white strip then it could be main board. i had one on a fs-1030d which turned out to be the main control board. the laser was writing from edge to edge of the page giving totally black prints. hope this helps