Kyocera FS1030D error

[AlisonB]

My Kyocera FS1030D is not printing and showing an error I cannot find described in it's manual - can anyone here identify what's wrong?

The red toner and paper indicators are flashing alternately, while the green ready indicator flashes first on it's own and then simultaneously with the green data indicator.

I have checked for a paper jam and found the paper is loading fine. The toner cartridge was replaced only the previous day so cannot be running low. Print quality was flawless up until the last page printed before this error showed so can't see any obvious explaination as to why it won't print now - any ideas?

[JustManuals]

This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after payment from The Internet's largest collection of manuals


Paul@justmanuals.com

[HmkPrinterTech]

Do the LEDS cycle like this pic?

[KdvA]

It looks like a 7990 error (Waste toner full)(> 100.000 pages) only the data indicator should be flashing to.
Shake the process-unit horizontally and switch the power off then on.
(or replace the process-unit)

[Warstg_20]

maybe so..

[randula7]

It looks like a 7990 error (Waste toner full)(> 100.000 pages) only the data indicator should be flashing to.
Shake the process-unit horizontally and switch the power off then on.
(or replace the process-unit)

if it is waste toner full you must pullout it.this printer process-unit can work over 200.000 prints but you have to maintenance well.
see the attachments.

[stigma]

if it is waste toner full you must pullout it.this printer process-unit can work over 200.000 prints but you have to maintenance well.
see the attachments.

I have the same error (7990) I have dumped the waste toner and inserted the cartridge again, but the printer (FS1010) still displays the same error. What can i do? Some kind of "reset" needed?

[kaborwen]

If the printer didn't run befor give error code, when you swish on, so check if fuser is ok.

[kaborwen]

if it is waste toner full you must pullout it.this printer process-unit can work over 200.000 prints but you have to maintenance well.
see the attachments.

Hi Randula7 It's Daniel from Burkinafaso, How are you? I think if it's not a wast toner problem, it's can be fuser (thermister or thermocontact problem).
Thanks and soon.