Lexmark MX-410 no transfer

**theengel** · 02-11-2019

I've got a machine that is not transferring. I swapped the transfer roller with one from another machine and there was no change. Would the power supply be next in line?

**driving lots of miles** · 02-11-2019

I assume you have tried a new image unit, after that there is not much use to spend time or effort as it is getting cost prohibitive to do much more. These boxes are throwaway.

**tsbservice** · 02-11-2019

Had once one KM 4050 which may be the same if I'm not mistaken. If you have blank print/copy try to change IU. It was the culprit in my case.
Good luck

**Lance15** · 02-12-2019

Not transferring as in no image? How about a half-print test? Any image on the IU(s)?

**Phil B.** · 02-12-2019

contacts in good shape?
yeah they are the cheaper line

they aren't using remans are they... had a cust using a China brand most were leaks..did have some FTP

**theengel** · 02-12-2019

You get a light image on the paper, when you do a stop test, you find that much of the image didn't transfer. That's what I mean by no transfer.

**Lance15** · 02-12-2019

Just realized this is a B&W unit.....duh!

Is the Imaging Unit okay? Worked on one of these last week and right after I updated the firmware, I started getting image defects from the same imaging unit that was in the machine when I arrived. Junk IU's.

**theengel** · 02-13-2019

Cust tried the imaging unit before I got there. But again, the drum has the image on it. It's just not transferring.

**Lance15** · 02-13-2019

Gotta suspect the transfer roller or power supply (combo LV & HV).

**Phil B.** · 02-13-2019

Originally Posted by theengel

Cust tried the imaging unit before I got there. But again, the drum has the image on it. It's just not transferring.

Ok.. then check the contacts..they used to be one assmy to the brds once I get to my paper I check the manuals... do you have them? If not..get with me.

Sent from my SM-G960U using Tapatalk