It is a relay board. This relay pwb, just collects all the wiring in that area and transfers it to the feed pwb located in the rear of the machine. ...
Every time I had messages like this ,with genuine toners installed , it was always the case of the toner cartridge contacts on the machine side were...
I can't tell you which models, but once they go into an error code the Settings Menu may become inaccessible. And if you replace the printhead while...
I've never seen the official bulletin, but it's no small task. On later production models they installed a new style front cover with holes to access...
If I were to guess, I'd guess that the U021 reset cleared the speed upgrade code, so it won't accept that toner, and it will run at 25ppm. I suspect...
So just to clarify: That line is crossfeed? If yes, start with the simplest of solutions: clean every rubber, metal, or plastic roller thoroughly. I...
I agree on this one. We have had a couple cases on high speed Konica Minoltas, in which fanning the paper made all the difference. Between us techs,...
I am a junior engineer working in the photocopier business for 4 years, i have recently been placed in the field, where I am undergoing training. I am fully aware of the brand I represent since 2011. |Kyocera