You didn't mention if you changed the transfer belt unless I missed it. Really the only thing left. I recently had one with first page defect and it...
Don't have much experience with Fiery's as Synthohol but have found there isn't much difference in print quality. Don't think it's worth $4000+ when...
Are you a technician or end user? It is very easy to remove and a tech would know this. Anyway I have attached FS-529 installation instructions, just...
Sounds like the home sensor or board. I never liked those hole punch units in the bigger finishers. They always had issues going all the way back to...
The other poster is correct check that the levers on the front wheels are in the up position and remove finisher. If all else fails you can remove 4...
You should start a new thread specific for the Biz C250i so your post wont get lost in this old thread. Would definitely update firmware first. Dont...
That is strange because once paper from by-pass is fed into machine it uses same process as paper fed from other trays. Could it be settings for 2nd...