Sounds like the home sensor or board. I never liked those hole punch units in the bigger finishers. They always had issues going all the way back to...
The other poster is correct check that the levers on the front wheels are in the up position and remove finisher. If all else fails you can remove 4...
You should start a new thread specific for the Biz C250i so your post wont get lost in this old thread. Would definitely update firmware first. Dont...
That is strange because once paper from by-pass is fed into machine it uses same process as paper fed from other trays. Could it be settings for 2nd...
Just bought this off lease machine and this message is showing, "The PDF / A font was not found. Please contact Service rep" Does this mean it has a...
I've had this many times. If the rear latch hook on top cover isn't broken then the rear hinge pin for top cover has come out. Remove rear cover and...