Tab Content
  • ron67601's Avatar
    1 Week Ago
    ron67601 started a thread MX-C428F in Sharp
    Just wanting to know if this is a good machine to sell? If anyone has any in the market they sold. This is probably a Sharpmark if I'm correct....
    see more
    4 replies | 465 view(s)
  • ron67601's Avatar
    1 Week Ago
    ron67601 replied to a thread FN27N trouble in Sharp
    They have updated the rollers and shafts. You will need to replace 0cwflo1960003 and order 0cwfe2e3420// and 0cwfe2d5050//. The bulletin is...
    see more
    3 replies | 526 view(s)
  • ron67601's Avatar
    2 Weeks Ago
    ron67601 replied to a thread "Settings have been changed..." in Sharp
    Reboot machine
    see more
    8 replies | 520 view(s)
  • ron67601's Avatar
    2 Weeks Ago
    ron67601 replied to a thread sharp mx 6580 in Sharp
    Sounds like it won't boot up. Did you check the lights on the MFP Board? Does your green power button blink or is it solid?
    see more
    5 replies | 642 view(s)
  • ron67601's Avatar
    4 Weeks Ago
    ron67601 replied to a thread MX-C357F Scanning in Sharp
    Ok thanks Hart for the response. Greatly appreciated.
    see more
    6 replies | 652 view(s)
No More Results

2 Visitor Messages

  1. dracon
    Hi
    Thank you for the information.
    But i donīt now remove the word print .
    i can not edit my post
  2. teckat
    remove the word Print from end of your post--------------so you can receive a reply

    [Canon ir-adv 8585 low intensity print]
    System has error when u use Print at end of post-and go to only a printable view and not a reply view
Showing Visitor Messages 1 to 2 of 2
About dracon

Basic Information

Statistics


Total Posts
Total Posts
16
Posts Per Day
0.01
Visitor Messages
Total Messages
2
Most Recent Message
05-16-2018
General Information
Last Activity
06-19-2022
Join Date
04-21-2016
Referrals
0
No results to show...