Tab Content
No Recent Activity

1 Visitor Messages

  1. gmamadog
    i have just installed a colorpass z400e on my clc 1180. i have installed the printer and interface board into the copier, but it will not recognize that the rip is attached. i went into service mode - options - int-face and tried to change B-CLR to "1" but it will not change. it justs keeps resetting to "0" value - no controller installed. any ideas or suggestions?
Showing Visitor Messages 1 to 1 of 1
About gmamadog

Basic Information

Statistics


Total Posts
Total Posts
7
Posts Per Day
0.00
Visitor Messages
Total Messages
1
Most Recent Message
10-04-2011
General Information
Last Activity
04-15-2022
Join Date
01-18-2011
Referrals
0
No results to show...