Tab Content
  • Hansen88's Avatar
    1 Day Ago
    I looked up the sim 3-10 value J and that looks very promising. If the customer has any more problems this sounds like it will cure for good. I think...
    6 replies | 304 view(s)
  • Hansen88's Avatar
    1 Day Ago
    Hansen88 replied to a thread Toshiba 4520C Calibration in Toshiba
    When you install the developer mix it already has the correct amount of toner mixed into it and that is what the 05/200 is calibrating to. Even with...
    7 replies | 190 view(s)
  • Hansen88's Avatar
    2 Days Ago
    Hansen88 started a thread Sim 44-17 in Sharp
    This sim 44-17 says development refresh, this is in a mx-465 book. What does this development refresh mean? I am pretty sure it is not the same as...
    1 replies | 105 view(s)
  • Hansen88's Avatar
    2 Days Ago
    Thanks guys, I installed the latest firmware and cleaned the paper path of the finnisher with anti static spray. It didnt do the problem anymore...
    6 replies | 304 view(s)
  • Hansen88's Avatar
    1 Week Ago
    Hello, I am working on a 3050N with fn-27 inner finisher and PN-14 hole punch. Customer is hole punching and stapling. The problem is on about 3 sets...
    6 replies | 304 view(s)
  • Hansen88's Avatar
    3 Weeks Ago
    It looks like the motor is behind the big board in back of machine obviously behind the toner cartridge. I think you just take stuff apart till you...
    4 replies | 275 view(s)
  • Hansen88's Avatar
    3 Weeks Ago
    Big deal he is going to miss the dinner. I could care less. I voted for him and I am glad to have him. He is already doing more to fufil his promises...
    100 replies | 3443 view(s)
No More Results
About Hansen88

Basic Information

Date of Birth
June 6, 1968 (48)

Statistics


Total Posts
Total Posts
141
Posts Per Day
0.05
General Information
Last Activity
1 Day Ago
Join Date
12-22-2009
Referrals
0

03-15-2017