Hello dear,
I have MFX2010 for Muratec.The machine says "replace fusing unit".
I'd like to know how to reset by pressing buttons.
Could you help me ?
Hello dear,
I have MFX2010 for Muratec.The machine says "replace fusing unit".
I'd like to know how to reset by pressing buttons.
Could you help me ?
Thank you for advice.
I have not the new fusing unit yet and I'm afraid it might not exist .I could reset drumunit .That has not a fuse,just press buttons.
May be This model is used in Asia and Europe.
I'd like to know if the fusing unit has a fuse to reset.
Could you give me some advice!!
I'm not a technician.but I have some kind of machines such as Konicaminolta,Sharp,Toshiba and etc.
I wonder Flag reset means likely machine parameter,I ca see the parameter number ,8digit such as 10000101.
Then changing the number,the fuser unit might be reset,right?
Thanks and I try to find out the place to change.
You are so helphull for me.
Thanks again.
If it were me, I would purchase a service manual, then read the appropriate section. Even an enduser can read a manual, yes? =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Bookmarks