The machine is with permanent error code F246, actualize the firmware is disconnected from the network but appears immediately turn the error code is always present.
How do I remove them?
The machine is with permanent error code F246, actualize the firmware is disconnected from the network but appears immediately turn the error code is always present.
How do I remove them?
Welcome Aboard!
--
Snap, Crackle, Aneurysm!
Welcome
If u still searching for solution go to http://www.copytechnet.com/forums/ky...mita-copystar/
good luck
This is the newbie check in area, where you can introduce yourself. If you have a Kyocera question you should post it in the Kyocera section.
Here's the short answer, though. Most likely you are getting some sort of unsuitable data coming to the MFP's IP address. It might be a wrong print driver, a corrupt document or website, or some type on non-print data that the machine cannot interpret. If the error pops back up the moment it's on the network, that's the confirmation. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
There is no magical reset for cf246. It clears by itself upon initialization. If the error occurs without a network connection you have corrupt firmware, corrupt CODE DIMM, or bad Main Board, in that order. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Bookmarks