Good morning, all.
Is it possible, on these ashtray-models, to configure them not to stop on consumables end-of-life (except for toner)?
Thank you.
Good morning, all.
Is it possible, on these ashtray-models, to configure them not to stop on consumables end-of-life (except for toner)?
Thank you.
' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!
Sorry for hijacking my own thread, but regarding the same machine:
After rechiping the IUs, the machine is now constantly either warming up or calibrating. Even when it prints, it start warming up or calibration right after it, and it sometimes takes more than 15 minutes to print again.
Anyone can give some insight on why this could be happening?
Thank you.
' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!
Bookmarks