Printer does not boot . there is power as the display shows a faint squares on display. when you switch off you see motor slightly move ?
Printer does not boot . there is power as the display shows a faint squares on display. when you switch off you see motor slightly move ?
Hi I could be wrong but I would suspect a power supply problem.
Regards Gordie
i was thinking the same, i have heard this box is the same as a xerox 3450dn.
so i take it the power supplies are interchangeable
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads
Paul@justmanuals.com
I also belive it to be power board failure, check the contact points on the board with your meter for correct voltage etc!!!! just to be certain...
Masterchief
We had one that used two power supplies within 6 months. The customer turned down the second one. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Bookmarks