Thanks:
0
Likes:
0
Dislikes:
0
-
Lanier 7328 Developer Calibration
Does anyone know how to get in the srvice mode for this machine.I need the developer calibration sequence as well.Help on this old machine would be greatly appreiciated.
-
Dev calibration turn off. Power up while holding 0 & 5. enter 0. press start. let run til machine reads adjust mode. press interrupt to enter setting. Power off. do this with new dev material installed as the standard. Normally the value will be correct. Machine is the same as a Toshiba 2060. copier has several service modes 0 & 5 is for adjustments. 0&8 is for settings. good luck.
-
Re: Lanier 7328 Developer Calibration
Do you know the codes to go along with the developer calibration. I am trying to set my unit's default brightness so I do not need to change it every time I try to copy something.
Thanks,
Scott
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks