Thanks:
0
Likes:
0
Dislikes:
0
-
mtt_mcmlln@yahoo.com
Guest
Panasonic DP-6010
Had a service call on this machine today and it was throwing a code E04-02. It seems that Intravia guides do not have any info on this machine. Found that E04-01 code to be a warmup problem and checked both lamps and both thermal fuses (good). Understand that there is a reset for fuser codes thru diagnostics... any help would be appreciated. Also, cannot seem to find parts suppliers for this machine. Thanks again, Matt
-
GO to service mode, function original size and 3 go f9, then
ram initialize and lbp reset thats it
-
Panasonic DP-6010
An E4-02 occurs after 7 consecutive jams at the fuser
-
Service Manager
250+ Posts
- Rep Power
- 39
E4-02 = Jam @ fuser unit.. Possible causes are:
Paper exit sensor# 1 or 2 disconnected or defective.
DRV pcb is disconnected or pcb is defective.
SPC pcb is disconnected of pcb is defective.
( Have also had the sensor flags stick, causing a jam situation.)
Hope it helps.. Good luck.
-
Technician
- Rep Power
- 0
hallo every body
i am new member
my names ehab rashed from egypt
i am panasonic copier engineer from 5 years ago
please i want psw *portable service workstation* install password
for dp 7000
i have this program but i haven't its install password
can any body can help to find this password please
thanks to every body
bye
-
Trusted Tech
50+ Posts
- Rep Power
- 33
Hi,
I agree with notaricohtek & yakyitz but check the basic things first after clearing the fault code check fuser seperator fingers, build up of toner on the entry guide etc. also check paper tray pick up rollers.
Gordie
-
Senior Tech
100+ Posts
- Rep Power
- 34
Make sure the exit sensors on the fuser are clean. After you have cleaned the sensors well go to F9 and Ram Initialize then do a LBP fuser reset. That should clear the Error code. If it keeps comming up after you do the fuser reset you need to check into the sensors.
-
Trusted Tech
50+ Posts
- Rep Power
- 32
I would check the actuator arm on t he fuser first. They tend to break or crack easily! did they paper get caught or it just stopped?
The machine will pop a E4-02 code after 3 fuser jam.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks