I can not enter the S.Mode of Panasonic DP 3030 ?

[KHAN]

Hello friends i press the Original size A3 key Function key and 3 key to enter the simulation mode of panasonic DP3030 copier but the screen remain on ready position and can not enter the S mode, i tried these keys individual it works its job .are some body blocked the simulation mode it is possible ? Please need help i just replace the Developer and want to run F8-09 mode.
Thanks.

[copiman]

Press the function key>Original size (Ledger/A3)>3.

When you press the function key keep holding down then press the original key and keep holding it down, then press the 3 key.

[onetek]

Lol just this morning I was showing that to our new tech. He also had trouble with the sequence....
Th.

[copiman]

I did to in the beginning.

[onetek]

Me too!
Th.

[KHAN]

Thanks friends for your kind help. Today i Run F8-09 to adjust the ATDC after replacing the Developer the machine run for about 5min and after it shows C00. I am new with this copier what is it mean or it it adjust the ATDC fine .
Thanks to all and GOD BLESS U ALL.

[onetek]

It meens that F8-09 ended and copier went back to F8-00 .Check your F6-21 before and after F8-09. What is it? I find that with oem dev and toner it usually sits around -36 right after F8-09. I have to tune it down later (between 50 to 100k copies) to -50 even to -60 sometimes.
Th.

[KHAN]

​Ok thanks i will check. Thanks for your help.

[toner-cartridge]

I have encountered this problem, but I do not know how to solve.

[User Name]

I have encountered this problem, but I do not know how to solve.

You need to press and hold down the keys in the correct order as mentioned above. If it still doesn't work, check to make sure all the keys are functioning properly.